Controlled Products Systems Group PAT1AC - Manual (Page 23)

21
STEP 16c LCR Remote/Transmitter & Receiver
(model 433DSR2LC)
Programming
The Transmitter and Receiver provided operate at 433 MHz. Receiver can store up to 22 unique transmitter codes.
Transmitter Setup: (It is recommended that the dipswitches be changed from the default setting)
1. Open the battery compartment door and locate the dipswitches.
2. Change the dipswitches to the settings you prefer. Record for future reference.
Transmitter Left Button to Receiver Programming: (standard Open/Stop/Close function)
1. Press and hold the left transmitter button down. Red light on transmitter should be on.
2. On the receiver, push the P1 push-button until the green LD light comes on.
3. Release both buttons. Transmitter left button to receiver programming is complete.
Transmitter Right Button to Receiver Programming: (Hold-Gate-Open) (Only if auto close timer is enabled)
The 2-channel receiver allows for programming the P2 relay from momentary mode (default) to latching mode.
Transmitter right button can then be programmed to hold the gate open, over-riding the auto-close feature if
activated.
1. Press and hold the right transmitter button down. Red light on transmitter should be on.
2. On the receiver, push the P2 push-button until the green LD light comes on.
3. Release both buttons. Transmitter right button to receiver programming is complete.
Receiver Programming: Relay P2 programming from momentary to latching mode (to hold gate open)
1. On the receiver, push the P2 push-button until the green LD light comes on, then release. Green LD light
should be steady.
2. While the green LD light is on, push the P1 push-button down and release. Green LD light should be flashing.
Latching mode is set.
Verifying Receiver P2 relay is programmed to latching mode:
1. On the receiver, push the P2 push-button until the green LD light comes on, then release.
2. Green LD light should be flashing. If the green LD light is steady, redo the Receiver Programming section
above.
Resetting receiver P2 relay to momentary mode:
1. On the receiver, push the P2 push-button until the green LD light comes on, then release. Green LD light
should be flashing.
2. While the LD light is flashing, push the P1 push-button down and release. Green LD light should be steady.
Momentary mode is set.
Erasing Single Transmitter from Receiver Memory:
The dipswitch settings of the transmitter to delete must be known. If known follow the steps below.
1. Set the dipswitches in a transmitter to match the switch settings of the transmitter code to delete.
2. Press and hold the left transmitter button.
3. On the receiver, push the P1 push-button until the green LD light comes on. Then release both.
4. Press and hold the right transmitter button.
5. On the receiver, push the P2 push-button until the green LD light comes on. Then release both.
6. Transmitter is now erased from receiver memory.
Erasing all Transmitters from Receiver Memory:
1. Press the P2 button on the receiver until the green LD light comes on. Then release P2 button.
2. While LD light is on press the P1 and P2 buttons simultaneously and hold until the green LD light begins to
blink slowly. It should blink 4 times then all transmitter codes are erased.
Contact the factory for advanced programming options.