Controlled Products Systems Group 4302-111 - Manual (Page 23)

4302-065-F-1-13 21
Cover Plate
CL AS S
CE RT IFI ED TO
CA N/ CS A C2 2.2 NO . 2 47 CO NF OR MS TO
ANSI /U L- 32 5
VE HI CUL AR G ATE O PE RAT OR
HP
53 38 2
MO DE L SE RI AL VO LT S
PH AS E
AM PS
60 H z
MA X GA TE LO AD
Do or Kin g, In c., Ing lew oo d, CA
2.3 Limit Sensors Adjustment Continued
6400 Limit Sensors ONLY
6 Slow Down
4 Slow Down
5 Limit
Limit Sensor Wire Color LEDs
Re-lock release handle
with key and test the gate
stopping positions.
Re-adjust if necessary.
Adjust the Secondary operator limit sensors if dual operators
have been installed. SW 1, switch 2 controls secondary
operator opening direction. SW 1, switch 7 MUST be ON
when using dual operators (See page 18).
Re-install the operator cover plate.
With operator cover plate removed, un-lock release handle and pull handle to release gate. A
B
C
D
E
Limit
Nut
Note: 3 and 5 limit LEDs can be
Open or Close limits depending
on SW 1, switch 1 and 2 settings
(See page 17).
Embedded magnet on underside
activates limit sensors when it
passes over them.
Limit assembly positions
may vary depending on the
operator’s drive motor
orientation. Limit sensor wire
color LEDs remain the same.
3 Limit
SW 1
Primary Operator
Secondary Operator
Single or Dual Operators
1 ON
2
3
4
5
6
7
8
3 Limit LED - Gray/White
4 Slo Dwn LED - Purple/White
5 Limit LED - Yellow/White
6 Slo Dwn LED - Brown/White
Power to the circuit board must be ON when adjusting the limit sensors.
Limit LEDs
Unlock...
...then pull handle
Limit
Assembl
y
Manually move the gate to the desired open
or closed position. Loosen limit nut and
slowly slide the limit assembly until the
corresponding
LIMIT LED on the circuit board
lights up and tighten nut.
Manually move the gate to other
position. Repeat process with
the other limit assembly.