Controlled Products Systems Group 4302-111 - Manual (Page 22)

4302-065-F-1-13 20
2.3 Limit Sensors Adjustment Continued
Limit
SlowDown Slow Down
Limit
6004 Limit Switches ONLY
Re-lock operator with
release tool and test the
gate stopping positions.
Re-adjust if necessary.
Adjust the Secondary operator limit rings if dual operators
have been installed. SW 1, switch 2 controls secondary
operator opening direction. SW 1, switch 7 MUST be ON
when using dual operators (See page 18).
Re-install the operator cover.
With operator cover removed, un-lock operator with
release tool to release arm. A
B
C
D
E Note: 3 and 5 limit LEDs can be
Open or Close limits depending
on SW 1, switch 1 and 2 settings
(See page 17).
SW 1
Primary Operator
Secondary Operator
Single or Dual Operators
1 ON
2
3
4
5
6
7
8
Power to the circuit board must be ON when
adjusting the limit sensors.
Limit LEDs
Top Limit
Ring
Bottom
Limit Ring
B
B
Adjustment
Screw
Adjustment
Screw
Manually move the gate to the desired open
or closed position. Loosen adjustment screw
and slowly spin the appropriate limit ring
until the corresponding
LIMIT LED on the
circuit board lights up , then tighten screw.
Manually move the gate to other
position. Repeat process with
the other limit ring.
Unlock
Release
Tool
4 Slow Down
6 Slow Down
5 Limit
3 Limit
Limit Switch LEDs
Limit Rings
D O O R K I N G
Cover
Limit Switch
Wire Colors
3 Limit - Orange (Bottom)
4 Slo Dwn - Red (Bottom)
5 Limit - Yellow (Top)
6 Slo Dwn - Green (Top)
(White wires are Common)
Electronic Pallet
Thru-Bolt 13 mm
Thru-Bolt
13 mm
Limit Switch Adjustment Note:
Two thru-bolts 13 mm can be
loosened to allow the electronic
pallet to be moved around a little.
Make sure ALL 4 limit switches
make good contact with the
2 limit rings.