Hach-Lange PHOSPHAX indoor sc - Manual (Page 13)

13
Section 3 Installation
DANGER
Only qualified personnel should conduct the tasks described
in this section of the manual.
CAUTION
Good safety habits and technique should be observed at all
times. Review all SDS/MSDS information and use
recommended safety measures to prevent exposure to
potential chemical hazards.
3.1 Basic installation overview
1. Unpack the instrument ( section 3.2 ).
2. Mount the instrument ( section 3.3, page 14 ).
3. Remove any transport locks ( section 3.4.2, page 19 ).
4. Install the collecting tray and the humidity sensor ( section 3.4.3,
page 20 and section 3.4.4, page 22 ).
5. Determine the appropriate installation option ( section 3.4.5,
page 23 ).
6. Mount the Filter Probe sc or Filtrax, if necessary. Refer to the
appropriate manual for more information.
7. Connect the Filter Probe sc or Filtrax to the PHOSPHAX sc, if
necessary. Refer to section 3.5.4, page 26 for the Filter Probe
sc. Refer to the Filtrax manual for more information.
8. Connect the Drain Heating Connection, if necessary
( section 3.5.5, page 27 ).
9. Make all plumbing connections ( Appendix A Plumbing and
connection options on page 65 ).
10. Install the reagents ( section 3.6, page 29 ).
11. Connect the PHOSPHAX sc to the sc1000 controller to supply
power to the system ( section 3.7, page 31 ).
12. Connect the data network ( section 3.8, page 32 ).
3.2 Unpack the instrument
CAUTION
Pay attention to the weight (approximately 31 kg) of the
instrument. Do not try to carry the instrument without
assistance. Use only suitable lifting tackle for transport.
Open the shipping container while it is on its end and then slide the
analyzer out of the cardboard.
The items supplied will vary depending on the order.
Standard items supplied for a minimal configuration:
• PHOSPHAX sc and User Manual
• Collecting tray
• Initial set of reagent and cleaning solution
• Fastening bracket and angle bracket
• Accessories for tubing and flow-through variant
• Plug set