Clear-Com FreeSpeak - Manual (Page 9)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 9 of 49
2.2.2.2 FS-BP MK II Beltpacks
1) Connect the PC to the beltpack using the beltpack registration cable.
2) Run Terminal Emulator on a Connection at baud 19200 8,N,1
3) Type “# 0174” note there is a space after the „#‟. The DECT will reset and the
terminal will start streaming characters. If characters are not seen, check cables,
baud settings, hit return on the Terminal Emulator and type “# 0174” again.
4) Run the DECT Loader – see the DECT Loader section further in this chapter
5) Power cycle the Beltpack.