Clear-Com FreeSpeak - Manual (Page 21)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 21 of 49
5 Basestation Upgrade Procedure
Software and Hardware Required
- Ethernet/Ethernet Cross-over Cable
- Xilinx USB Programmer
- CellCom/FreeSpeak Registration Cable
- Memory SIMM (older units only)
- Boot PROM (older units only)
- Latest version of Application Code (found on CD)
- Latest version of Xilinx Code (found on CD)
- CellCom/FreeSpeak PC ToolKit
- Valid v2.0 Passcode
5.1 Basestation Application Upgrade
From v2, application code is upgraded using the Configuration Editor program, which
be found on the release CD. This replaces the Ethernet Upgrader program.
If for some reason, the application code cannot be upgraded using the ethernet
upgrade method (such as complete failure of the ethernet port), an alternative
method can be employed serially using Hyperterminal, S4 driver or equivalent.
To upgrade the Basestation, follow the flow charts on the next two pages.