Clear-Com FreeSpeak - Manual (Page 19)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 19 of 49
3.3 Active Antenna Bootloader
The active antenna bootloader is only required for Antennas that
have never had an application loaded into it.
You will need to install the Flash Development Toolkit (FDT).- obtainable from
3.3.1 Active Antenna Bootloader
Install the Flash Development Toolkit (FDT) Details on configuring the FDT are in
appendix.
Details on configuring the FDT are in the appendix
To upgrade the antenna bootloader, connect it to the PC using the beltpack
registration cable supplied with your base station.
Antenna firmware can be found in the "Firmware\Bootloader" directory of the CD.
3.3.1.1 Upgrade Procedure
1. Remove all the screws from the Active Antenna (apart from the bottom ones),
then slide the cover off.
2. Put the Active Antenna (AA) into BootMode by putting a Jumper onto Link 3
(LK3, the 3rd from the edge).
3. The jumper could be moved here from LK1.
4. Power up the AA (or press the Red reset button. if already powered up).
5. Connect the beltpack registration cable between the PC and the AA.
6. Run FDT on the PC. - Configured to
a. Device - H8S/ 2318/f,
b. CPU Crystal Frequency - 10.36Mhz,
c. Boot mode,
d. 19200 baud
7. Right Click on Bootloader01a.mot (or whatever is the current version) and
Download File to Device.
8. When this is complete, close FDT and power off the AA.
9. Put the AA into Normal Mode by removing the Jumper from Link 3. Put it back
on LK1 if that's where you got it from.
10. Power up the AA. The Green status LED (next to LK7) should start blinking to
indicate that the Bootloader is waiting for comms from the PC.