Clear-Com FreeSpeak - Manual (Page 4)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 4 of 49
1 Introduction
This document replaces the following previously released documents on the
CellCom/FreeSpeak release CDs :-
1. CellCom/FreeSpeak Active Antenna Firmware Upgrade Procedure
2. CellCom/FreeSpeak Active Antenna DECT Update Procedure
3. CellCom/FreeSpeak Beltpack Firmware Upgrade Procedure
4. CellCom/FreeSpeak Beltpack DECT Update Procedure
5. CellCom/FreeSpeak Upgrading Beltpacks Readme
6. CellCom/FreeSpeak Upgrading Splitters Procedure
It also includes details of installing and configuring the Flash Development Toolkit.
For Beltpack and Antenna upgrades the “FreeSpeak Upgrader” is required.
For DECT upgrades the “Flash Downloader” is required.
For Splitter upgrades the “Flash Development Toolkit” (FDT) is required.
For Base station upgrades the “Configuration Editor” and a valid passcode is
required.
NOTE: This document may also be used to update the Wireless Beltpacks,
Active Antennas and Splitters on the Eclipse System.
YOU WILL NEED A VAILD SYSTEM PASSCODE TO USE
FREESPEAK/CELLCOM V2