Clear-Com FreeSpeak - Manual (Page 46)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 46 of 49
9 Fold the connected
upper boards over
towards the rear of the
unit.
Place the XLR
connector so that it
straddles
the lower
board
Line up the connector
between the top and
bottom halves. This
can be mis-connected
without due care
Adjust the XLR
connector and the two
halves together
10 Replace battery clip
Power
Program the DECT as
required
Repeat steps 4
– 9
changing the dip
switches back to the
default.
See Preparing FS-BP MK
I & PD2202 Beltpacks
Only
for the default
dipswitch settings