Clear-Com FreeSpeak - Manual (Page 17)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 17 of 49
Kirk Module
RM5 Module
3.2.3 “Flash Downloader” for Antenna DECT updates
1) Install the DECT loader onto a PC with a serial port.
2) Connect the PC to the Antenna using the Beltpack registration cable.
3) Start up the Flashloader program, set as follows with the correct DECT
update file selected in “Target Final Flash Executable”.
4) Power up the Antenna select start. The DECT should start updating; the
status will change from “idle” to “erasing flash”.
5) The ildr_425.hex can be found in the DECT images directory.
6) The “auto start” will begin if you save and restart the flash downloader
application on your PC. Having previously saved the correct settings and the
antenna is connected and power up.