Clear-Com FreeSpeak - Manual (Page 12)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 12 of 49
8. Run FDT on the PC - Configured to
c. Device - H8S/ 2318/f,
d. CPU Crystal Frequency - 10.36Mhz,
e. Boot mode,
f. 19200 baud
9. Select Bootloader01a.mot (or the latest version) and Download it to Device
10. When this is complete, close FDT and power off the Beltpack by removing at
least one battery.
11. Put the Beltpack back into Normal Mode by changing the following jumpers:
g. ON/OFF to OFF
h. MD2 to OFF.
12. Replace the battery and power up the Beltpack. The Green status LED
(LED2) should start blinking to indicate that the Bootloader is waiting for
comms from the PC.