Clear-Com FreeSpeak - Manual (Page 11)

CellCom/FreeSpeak Firmware Update Procedures
Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 11 of 49
The auto start will begin on starting the flash downloader app with the BP connected
and powered on.
After the DECT is upgraded:
2.2.3.1 FS-BP MK I & PD2202
Turn off the BP, disconnect the power or remove a battery and set the Dipswitches
back to their normal operating position.
Reassemble the BP (see the section on opening beltpacks) install the batteries,
power up and check that the BP versions are correct in the version menu.
2.2.3.2 FS-BP MK II
Power cycle the beltpack and check that the BP versions are correct in the version
menu.
If the BP is not connected to a system, the version can be displayed by tapping the
up/right menu button from the “searching screen”.
2.3 Beltpack Bootloader
ONLY UPDATE THE BOOTLOADER IF THE BELTPACK HAS NEVER HAD
SOFTWARE INSTALLED PREVIOUSLY.
The bootloader is usually installed once at the factory production stage and is not
required for routine system upgrades. Skip to the “Beltpack Application” if the
beltpack already has ever had a version of software installed.
You will need to install the Flash Development Toolkit (FDT).- obtainable from
Before you begin ensure that batteries are fully charged.
Beltpack firmware can be found in the "Firmware\Bootloader" directory of the CD.
2.3.1 Upgrade Procedure
1. Install the Flash Development Toolkit (FDT). Details on configuring the FDT
are in appendix.
2. Remove at least one battery from the Beltpack.
3. Remove all the screws from the Beltpack, and remove the cover.
4. Slide main PCB assembly off and place to the side of the case.
5. Use a sharp implement to put the Beltpack into Boot mode by changing the
following DIP switch settings – details show the DIP switch legends on the
board:
a. ON/OFF to ON
b. MD2 to ON.
6. Power up the beltpack by replacing the battery(s).
7. Connect the beltpack registration cable supplied with your base station
between the PC and the Beltpack.