Clear-Com Eclipse-Omega - Manual (Page 45)

Clear-Com
Eclipse Omega Instruction Manual 2 - 2 5
a corresponding rear-connector panel. Blank panels cover unused
slots.
Each port on the matrix can be located and identified by using the
rear-panel numbering grid.
• Columns 1 through 15 identify cards.
• Rows 1 through 16 identify ports on each card.
• Processor cards are designated P1 and P2.
A port can be identified precisely by identifying its card number and
port number on the card. For example, the ports on the first card are
designated 1-1, 1-2, 1-3, 1-4, and so on; the ports on the second
card are designated 2-1, 2-2, 2-3, 2-4, and so on.
Each rear connector panel associated with an E-QUE interface holds
eleven RJ-45 ports:
• Eight ports for connection to wireless equipment.
• Two ports for DECT sync.
• One port for LAN interface.
Each rear connector panel associated with an IVC-32 interface holds
eleven RJ-45 ports:
• Eight ports for connection to E1/T1 equipment (not used).
• Two ports for DECT sync (not used).
• One port for LAN interface used for IP-enabled V-Series panels and
Concert panels.
Each rear connector panel associated with an LMC-64 interface holds
eleven RJ-45 ports:
• Eight ports for connection to E1/T1 equipment (not used).
• Two ports for DECT sync (not used).
• One port for LAN interface used for broadcasting audio levels to
Production Maestro Pro clients.
Each rear connector panel associated with an E-FIB interface holds
two fiber ports (TXVRA and TXVRB).