beautypg.com

Clear-Com HX System Frames User Manual

Page 73

background image


Important note:

Figure 25 shows an unconfigured E-MADI64 card , when all lights are lit to indicate their location.

On a card with a clock source and MADI connections ( where the received MADI signal matches the
card set up), the following lights are lit: the Lock source LED
[ ], the Sample rate (Fs) LED
[ ], the Channels LED [ ] and the Active LED [ ]. The Error LED [ also ] is lit when
there is no clock source or MADI input.

Key to E-MADI64 front panel lights and controls

Feature

Description

A

Reset button

Pressing the Reset button causes the card and all links to momentarily stop
their current activity and to restart. The

flashing green

Active light goes off

when the reset starts and comes back on when the reset is complete.

During the reset, configuration information downloads to the card and its
connected matrices from the CPU card. If the entire system is operating
except for one E-MADI64 card, press the reset button for that card only.

Tip:

The reset button is slightly recessed from the front panel to prevent it

from being accidentally pressed. A tool such as a bent paper clip is needed to
press this button.

B

+3.3-Volt Power Supply LED

The matrix +3.3-volt power supply provides electric current to this

green

light.

When lit, the light indicates that the +3.3-volt supply is present and supplying
electric current to the card.

C

Lock source

A

green

light indicates that the E-MADI64 card has locked to the clock source

(either video (VID) or Word Clock (WRD)).

C

D

E

F

F

73

Eclipse HX-Delta User Guide

This manual is related to the following products: