beautypg.com

Clear-Com HX System Frames User Manual

Page 58

background image


Key to CPU card lights and controls

Feature

Description

A

RESET button

Pressing the RESET button causes the CPU card to stop its current activity
and to restart. The same configuration that was active before the system was
reset will be active after the system was reset.

During the reset, configuration information reloads to the card’s operational
memory from its non-volatile memory and the card starts running again from
the beginning.

The reset button is slightly recessed from the front panel to prevent it from
being accidentally pressed. A tool such as a bent paper clip is needed to press
this button.

B

Power supply lights

+ 5-Volt light

When lit

green

, the +5V light indicates that the matrix’s +5-volt power supply

is actively supplying power to the CPU card.

+3.3-Volt light

When lit

green

, the +3.3V light indicates that the matrix’s +3.3-volt power

supply is actively supplying power to the CPU card.

C

Dot Matrix lights

The rectangular array of lights just below the power-supply lights displays a
number (either 1, 2, 3, or 4) to indicate the currently selected configuration.
The EHX configuration software controls these lights.

In addition these lights will indicate if the following errors are detected at
startup:

NVRAM error

When the NVRAM is found to be corrupt at start up the config card will output
the string CHECK BATTERY.

Non matching slave firmware

The Eclipse HX system only supports master and slave backup between two
cards that are running the same version of firmware. In the case when a non
matching slave card firmware version is detected the NON-MATCHING
SLAVE_FIRMWARE
message is displayed by the master CPU card.

Hardware version verification

When an older, unsupported version of the MVX or E-QUE FPGA is detected,
the EQUE FPGA VERSION USUPPORTED message is displayed by the
master CPU card.

58

Eclipse HX-Delta User Guide

This manual is related to the following products: