Clear-Com HX System Frames - Manual (Page 27)

4 Installing the
Eclipse HX-Delta
This chapter describes how to install the Eclipse HX-Delta, including the power supplies,
CPU cards, interface cards and modules.
4.1 Before you begin the installation
4.1.1 Check the shipment
When the Eclipse HX-Delta is received, inspect the boxes for shipping damage. Report any
shipping damage to the carrier.
Check that every item on the packing list has been received. Save all packing materials in
the event that any items need to be returned.
Note:
The Eclipse HX distributor is not responsible for shipping damage.
4.1.2 Unpacking the System
When the Eclipse HX-Delta system is received the CPU cards and interface cards, power
supplies, and rear-connector panels are pre-installed in the matrix chassis.
The customer must supply:
• The standard 19-inch rack in which to install the matrix.
• A personal computer to run the EHX configuration software
Note:
See 12.24 Minimum PC requirements (for EHX software) and 12.25 Recommended PC
requirements
(for EHX software)
respectively.
• CAT5 cables (to connect the matrix to user panels, interface modules, and other
devices). Clear-Com recommends shielded cables.
27 Eclipse HX-Delta User Guide