Atlantis Land I-Storm A02-RA(Atmos)_ME01 - Manual (Page 76)

snmp 161/UDP
tftp 69/UDP
telnet 23/TCP
mymachine>
ip config save
Updating flash filing system ...
done
ip: configuration saved
10.7 device
10.7.1 Syntax
device [list]
device add [] [mtu ] []
device delete
device flush
10.7.2 Description
Displays the interfaces that IP is configured to use (device list), or adds an interface
to the configuration (device add), or deletes an interface (device delete), or deletes all
interfaces (device flush), from the configuration.
The options used with this command are described below:
• is an arbitrary label for the interface, which is used in referring to it in
subsequent commands. (It is often chosen to be the same as >, though this is
perhaps slightly confusing.)
• specifies the class of interface: Ethernet-like, IP-over-ATM, PPTP or
loopback.
The supported values for are shown in the table below:
Class Default file
Ethernet ether value of
ETHERNET_DEVICE_NAME
(defined in system file)
flane //lec1
bridge //bridge
IP-over-ATM atm //q93b
atmpvc //bun
//atm
Point-to-point PTP None
PPP //ppp/DEVICE=1
Loopback loop -
A default file for the Ethernet class can be defined in the system file, as follows: