Atlantis Land I-Storm A02-RA(Atmos)_ME01 - Manual (Page 63)

This command specifies that when using this channel, the user must log on using the
specified protocol, and that they must provide any name/password combination
which has been defined for that protocol, using the user command.
To remove this information on a channel, call theylogin with a single argument of
none.
Configuration saving saves this information. By default, no login is required.
8.22 tunnel
8.22.1 Syntax
tunnel
8.22.2 Description
Logically associate the specified channel with the specified PPTP tunnel.
A single PPP channel can only be associated with a single interface, or a single
tunnel.
Use info to find the current setting.
Calling with n=0 removes any association. This is the default state.
Configuration saving saves this information.
The possible tunnel protocols are: pptp and l2tp.
The dial direction may be: in or out for dial-in or dial-out respectively.
8.22.3 Example
ppp 3 tunnel 1 pptp out
8.23 welogin
8.23.1 Syntax
welogin [pap|chap]
welogin none
8.23.2 Description
This command describes how we should log in to the far end when a connection is
established. A name and password are supplied, and whether these should be used
with the PAP or CHAP authentication protocol. CHAP is the default.
To remove this information on a channel, call welogin with a single argument of
none.
If
chap
is specified, we will also log in using
pap
if the other end prefers this. If
pap
is specified we will only log in using
pa
p.
Configuration saving saves this information. By default, no login is performed.
8.24 bcp