Atlantis Land I-Storm A02-RA(Atmos)_ME01 - Manual (Page 69)

9.6.2 Description
Explicitly disconnect a tunnel (the opposite of connect). All data connections across
the tunnel are terminated and the control connection is closed.
If the tunnel object is associated with a particular remote PNS (as created with
create >), it may be reconnected later, either explicitly with
another connect command, or implicitly by PPP requesting to use it.
If the tunnel object is allocated to the listener (as created with create
listen), it is freed for use by future incoming connections.
9.6.3 Example
To disconnect Tunnel 1, enter:
pptp 1 disconnect
9.7 event
9.7.1 Syntax
event []
9.7.2 Description
Read or set the trace output level for a tunnel.
Configuration saving does not save this value. The default event level is 1; only very
serious errors are reported.
The Event levels are listed in the table below:
Level Description
1 Only very serious errors reported (default)
2 Definite protocol errors or very significant events reported.
3 Channels going up/down reported.
4 Every packet and significant state change is reported.
5 Every packet sent/received is disassembled, and hex dumped.
9.8 info
9.8.1 Syntax
info [all]
9.8.2 Description
Provide information about the current settings of this tunnel. This includes all
configured state, and also current protocol information.
Specifying all prints out more information.
info and status are synonyms.
9.9 list