Atlantis Land I-Storm A02-RA(Atmos)_ME01 - Manual (Page 58)

Learning occurs in this direction only.
Setting hdlc to 0 clears this learned state. Configuration saving does not save the
learned state.
8.11 info
8.11.1 Syntax
info [all]
8.11.2 Description
Provide information about the current settings of this channel. This includes all
configured state, and also current protocol information.
Specifying all prints out more information.
info and status are synonyms.
8.12 interface
8.12.1 Syntax
interface
8.12.2 Description
Logically associate the specified channel with the specified interface.
Interface 1 is always the router port. It should be used for any PPP channel over
which IPCP communication with the local system’s IP router is desired. Other
interfaces can be created for bridging. A single PPP channel can only be associated
with a single interface, or a single tunnel.
Use info to find the current setting.
Calling with n=0 removes any association. This is the default state.
Configuration saving saves this information.
8.13 lcpmaxconfigure
8.13.1 Syntax
lcpmaxconfigure []
8.13.2 Description
Set the Max-Configure parameter for LCP, as described in Section 4.6 of RFC1661.
This is the maximum number of Configure Requests that will be sent without reply,
before assuming that the peer is unable to respond.
Call with no argument to find the current setting.
The default value is 10.
Configuration saving saves this information.
8.14 lcpmaxfailure