Default settings – ELRO HA68S Multi-zone professional alarm system USERS MANUAL User Manual
Page 25
-23-
-42-
User Setup
Password
Admin: 1234
User 1~5: Not
Programmed
Name
Admin. User 1~5
Tel Remote
Admin: ON
User 1~5: OFF
Record User
Message
Not Programmed
Replay User
Message
Not Programmed
Remoter
Not Programmed
System Setup
Alarm Time
180s
Internal Siren
ON
External Siren
ON
Auto Report
ON 12h
RF Jamming Detection
OFF
Back Light
10s
Error Beep
OFF, 30s
Alarm Relay
ON until Disarm
Call Abort
OFF
Key Tone
ON
GSM Dialer
OFF
Dialer Mode
Voice
Wirefree Siren
ON
Wirefree Keypad
OFF
Zone Lock
ON
Zone Setup (1-36)
Name
No Name
Type
Intruder
Chime Mode
OFF
Entry Delay
Zone 1-36
OFF, 30s
Partial Arm 1
OFF
Partial Arm 2
OFF
Magnetic O/C Detector
ON
Auto Report
ON
Zone Status
OFF
Zone Reset
Not Programmed
Zone Siren
ON
Telephone Setup / Voice Dialer
Phone Numbers
Not programmed
Record Voice
Not Programmed
Play Voice
Not Programmed
Alarm Dial
All numbers
disabled
Tel Confirm Times
1
Dial Round
3
Play Time
70s
DEFAULT SETTINGS
Default setting: 1
Scroll through the menu until ‘:5 TEL Confirm’ is displayed. The current
settings will also be displayed.
To change the setting press .
Enter the required number (1-6).
Press to save and exit, or
Press to exit without saving.
DIAL ROUND
This sets the maximum number of times that the dialer will attempt to contact
each enabled telephone number in the call routing sequence.
Default setting: 3
Scroll through the menu until ‘:6 Dial Round’ is displayed. The current setting
will also be displayed.
To change the setting press .
Enter the required number (1-9).
Press to save and exit, or
Press to exit without saving.
ALARM MESSAGE PLAY TIME
This is the total time for which the alarm messages will be played & repeated
when a call made by the voice dialer is answered.
Default setting: 70s
Scroll through the menu until ‘:7 Play Time’ is displayed. The current setting
will also be displayed.
To change the setting press .
Scroll through the available options, (50, 70, 90 and 110s) until the required
setting is displayed.
Press to save and exit, or
Press to exit without saving.
Telephone setup/ digital dialer.
Phone
Not Programmed
Unit ID No.
Not Programmed
Call Attempts
3
Open/Close by
User
OFF
Telephone setup/remote telephone
control
Remote Telephone
Control
OFF
Remote Type
One Call
One Call Ring
Ring 6
Double Call Time
13s
Dial Method
DTMF
Fully arm setup
Exit Delay
ON, 30s
Entry Delay Beep
ON
Exit Delay Beep
ON
Partial arm 1 setup
Exit Delay
ON, 30s
Entry Delay Beep
ON
Exit Delay Beep
ON
Partial arm 2 setup
Exit Delay
ON, 30s
Entry Delay Beep
ON
Exit Delay Beep
ON
Time & date setup
Date
01/01/05 Sat.
Time
12:00:00
Latchkey setup
Set Latch Key
All OFF
Set Partial User
OFF
Set Latch Key
Tel Number
Not Programmed
EN
EN