Burkert Type 8750 - Manual (Page 17)

17
Control and display elements
Typ 8750
description of the display display
Simultaneous display of the nominal position
and the set-point position of the valve
actuator (0 – 100 %)
MENU CMD/POS POS MANU
0.0 sp
pV 0.0
m3/min
m3/min
Graphical display of SP and PV with time
axis
MENU HOLD SP / PV (t)
Graphical display of POS and CMD with
time axis
MENU HOLD CMD / POS (t)
Value overview
Pressure sensor P1 and P2
MENU P.LIN SP/PV MANU
0.0 p1 bar
p2 bar 0.0
Time, weekday and date
MENU POS (t) X.TUNE INPUT
12:00
00
thu. 01 . 09 . 11
CLOCK
Automatic adjustment of the position
controller
MENU CLOCK P.TUNE RUN
X.tune
description of the display display
Automatic optimization of the process con-
troller parameters
MENU X.TUNE P.LIN RUN
p.tune
Automatic linearization of the process
characteristics
MENU P.TUNE CMD/POS RUN
p.lin
Simultaneous display of the nominal position
and the set-point position of the valve
actuator
(0 – 100 %)
MENU P.LIN SP/PV MANU
0.0 cmd
pos 0.0
Tab. 6: Display in the AUTOMATIC operating state
8.5. master code
Operation of the device can be locked via a freely selectable user
code. In addition, there is a non-changeable master code with which
you can perform all operator control actions on the device. This
4-digit master code can be found on the last pages of this quickstart
guide in the Chapter “Master code”.
If required, cut out the code and keep it separate from this quickstart
guide.
english