FlexLink XK Функциональные модули Руководство пользователя - Manual (Page 38)

30 5114899
Put out of commission
7 Put out of commission
At the moment a module is put out of operation for some reason, a number
of steps are to be taken in order to avoid dangerous situations. This section
clearly indicates how one should proceed in a number of cases with re-
spect to uncoupling, dismounting, transport and reuse of materials coming
from the elevator
7.1 Disconnect the power sources
Prior to starting the dismounting, the voltage is to be cut off from the power
source. First the main switch is to be switched off before the power source
can be disconnected.
.
Danger: First switch off the main switch before the power source
may be disconnected.
7.2 Disassemble
While dismounting the machine, the regulations for waste processing ap-
plicable on the place and at the time of the dismantling are to be complied
with. The machine only contains commonly known materials. At the time of
assembling the module there were processing possibilities for this and no
particular risks were known for persons involved in dismantling. The disas-
sembly of the module generally requires few operations. The module can
be disposed of in the same way as it was delivered.
.
Note! At the time of assembling the modules there were
processing possibilities for this and no particular risks were
known for persons involved in dismantling.
Dust, dirt and liquides can accumulate in different cavities in the
module. Use appropriate personal protection during disassembly.
7.3 Reuse
No fixed rules have been made up for reuse of the modules, because the
module does not contain any hazardous substances. At the time of assem-
bling the module there were processing possibilities for this and no partic-
ular risks were known for persons involved in the reuse.
.
Note! Putting the module out of operation with all operations
involved may only be done by technically qualified personnel.