Asante Technologies 5212 - Manual (Page 85)

Configuration Menu
Page 5-35
Resetting EEPROM to Default
This option resets the IntraSwitch 5212’s EEPROM values to
their factory default settings.
▲
Important! This procedure reverts all informa-
tion to the factory default settings except for the
IntraSwitch 5212’s IP address, subnet mask, and
default gateway.
See "Factory Defaults" on page 1-10 for a list of
all the switch’s factory default settings.
To reset the EEPROM:
1 Type e from the Configuration Menu.
The following command line appears at the bot-
tom of the Configuration Menu.
Figure 5-15 Reset EEPROM to Default command line
2 Type y to reset the EEPROM to default or n to
cancel the reset.
3 Reset the IntraSwitch 5212 by manually turning
its power off and then on again.
The IntraSwitch 5212’s EEPROM is reset to its
factory default settings.
book Page 35 Monday, March 2, 1998 4:27 PM