Asante Technologies 5212 - Manual (Page 82)

Console Management
Page 5-32
3 Select the port number you want to enable
or disable Spanning Tree on by typing l on
the Port Parameter Menu and entering the
port number at the prompt.
∆
Note: The 10/100TX port is port num-
ber 13, the installed Asanté MII module is
port number 14.
4 Press Return.
5 Type e to enable Spanning Tree on the port;
type d to disable Spanning Tree on the port.
6 Type q to exit this menu and return to the
Spanning Tree Parameter Menu.
7 Type a to apply the changes.
▲
Important! The change will not take
effect until Apply is selected from the
Spanning Tree Parameter Menu.
book Page 32 Monday, March 2, 1998 4:27 PM