Asante Technologies 5212 - Manual (Page 79)

Configuring Spanning Tree Parameters
Page 5-29
Configuring Spanning Tree Parameters
This menu allows you to view the IntraSwitch 5212’s Spanning
Tree parameters. It also allows you to enable or disable
Spanning Tree on all of the switch’s ports or on a single port.
By default, the IntraSwitch 5212 is shipped with Spanning Tree
enabled on all ports.
▲
Important! You should be familiar with the
IEEE 802.1d specification before attempting to
change these Spanning Tree parameters.
To access the Spanning Tree Parameter Menu, type s from the
Configuration Menu. The following menu appears.
Figure 5-9 Spanning Tree Parameters Menu
Current Settings
Table 5-9 explains each setting on the Spanning Tree
Parameter Menu.
For information on using the menu, see:
❏ "Enabling/Disabling Spanning Tree on ALL
Ports" on page 5-31
❏ "Enabling/Disabling Spanning Tree on a Sin-
gle Port" on page 5-31
Current Settings;
these values
cannot be
changed
book Page 29 Monday, March 2, 1998 4:27 PM