MoTeC MDD User Manual
Page 34
32
BR2 Operation (with ECU)
is lost. A BR2 power cycle switch would provide a simple method to reset
fastest lap before a session.
BR2 Beacon Diagnostics
If an invalid beacon (i.e. Not the beacon configured in the BR2 to generate lap
times) is passed twice without passing a valid beacon, then the BR2 fault
message is displayed, as shown below:
Note that this condition only applies for the first invalid beacon found after a
valid beacon or after power up. The fault message indicates that either the
BR2 is not configured correctly for the MDD and for the beacon transmitter
being used, or that the beacon transmitter is incorrectly configured, faulty or
missing.