B&K Precision 4034 - Manual - Manual (Page 57)

57
Type: NRf
Units: S (seconds), MS (milliseconds), US (microseconds), NS nanoseconds
Range: 5NS to 10MS
Rounding: To current resolution
Examples: :PULS:TRAN:LEAD 50NS
:PULS:TRAN 85NS
QUERY
Syntax: [:SOURce]:PULSe:TRANsition[:LEADing]?
Examples: :PULS:TRAN:LEAD?
Response: NRf
CONSIDERATIONS:
The allowed value of the leading edge time is limited by the values of the period, width and
delay. In addition, the ratio between the transition times is limited to a maximum of 20:1, and
both transition times must be in one of the following ranges:
5ns to 100ns
50ns to 1 us
500ns to 10us
5us to 100us
50us to 1ms
500us to 10ms
4.12.1.18 Trailing Edge Time
This command is used to set the value of the trailing edge time. If the edge-tracking feature is ON,
changing the trailing edge will cause the same change in the leading edge.
COMMAND TYPE: Setting or Query
SETTING
Syntax: [:SOURce]:PULSe:TRANsition[:TRAiling][units]
Arguments:
Type: NRf
Units: S (seconds), MS (milliseconds), US (microseconds), NS nanoseconds
Range: 5NS to 10MS
Rounding: To current resolution
Examples: :PULS:TRAN:TRA 50NS
:PULS:TRAN:TRAiling 85NS
QUERY
Syntax: [:SOURce]:PULSe:TRANsition[:TRAiling]?
Examples: :PULS:TRAN:TRA?
Response: NRf
CONSIDERATIONS:
The allowed value of the trailing edge time is limited by the values of the period, width and
delay. In addition, the ratio between the transition times is limited to a maximum of 20:1, and
both transition times must be in one of the following ranges:
5ns to 100ns
50ns to 1 us