B&K Precision 4034 - Manual - Manual (Page 47)

47
4.11.4.3 *ESR? - Standard Event Status Register Query
This query is used to read the value of the Standard Event Status Register. Reading the register clears
it.
COMMAND TYPE: Common Command or Query
Syntax: *ESR?
Response:
4.11.4.4 *PSC - Power-On Status Clear Command
This command is used to control the automatic power-on clearing of certain status functions.
COMMAND TYPE: Common Command or Query
COMMON COMMAND
Syntax : *PSC
Arguments:
Type: Boolean
Examples: *PSC ON or *PSC 1
*PSC OFF or *PSC 0
QUERY
Syntax: *PSC?
Response: ASCII 0 for OFF
ASCII 1 for ON
When set to ON (1), the Service Request Enable Register and the Standard Event Status Enable
Register are cleared on power-on.
4.11.4.5 *SRE - Service Request Enable Command
This command sets the Service Request Enable Register bits.
COMMAND TYPE: Common Command or Query
COMMON COMMAND
Syntax: *SRE
Arguments:
Type: NRf
Range: 0 to 255. Non integer arguments are rounded before execution.
The value of bit 6 is ignored, and is set always to zero.
Examples: *SRE 48 (Enables reporting of ESB and MAV events)
QUERY
Syntax: *SRE?
Response:
f) STB? - Status byte query
This query is used to read the value of the Status Byte.
COMMAND TYPE: Common Query
Syntax : *STB?