Atec Rohde-Schwarz_FSL Series - Manual (Page 36)

R&S ® FSL Spectrum Analyzer Version 09.00, December 2008 36
Measurement parameters
predefined bands preset combinations of sampling rate (F
s
)
and nominal channel bandwidth (BW) in
line with standard
Frequency band
unspecified standard-compliant or user-defined F
s
/BW
ratios
Sampling rate (F
s
),
channel bandwidth (BW)
If one of the parameters is set, the other is
automatically set as required for the
selected standard. The frequency band
setting is taken into account.
Guard period ratio G = T
g
/ T
b
1/4, 1/8, 1/16, 1/32
N
FFT
128, 512, 1024, 2048
downlink (DL) DL-PUSC, DL-FUSC, DL-AMC 2×3 Zones
uplink (UL) UL-PUSC, UL-AMC 2×3
DL in line with signal DL-MAP (auto demod.),
normal DL-MAP, compressed DL-MAP Signal analysis
DL, UL in line with user-defined frame
configuration
IDcell 0 to 31
Segments DL-PUSC 0, 1, 2
preamble mode, auto derived from IDcell and segment setting in
line with standard Preamble
preamble mode, user defined by preamble index in line with
standard
Subchannel bitmap used DL-PUSC 6-bit mask allocating subchannel groups to
a segment
Burst modulation format BPSK (pilots only), QPSK, 16QAM,
64QAM
DL, UL phase ON/OFF, timing ON/OFF,
level ON/OFF
use pilots in line with standard
20
Pilot tracking
DL, UL
use detected pilots 21
preamble only
preamble and payload DL
payload only
Channel estimation range
UL payload only
Zone editor
DL, UL zone type, segment, length in symbols,
offset in symbols, PermBase Zone/segment list
DL PRBS_ID
Zone/segment map graphical display of frame content defined
by zone/segment list
Max. number of zones/segments per
subframe/frame 26
Burst editor
DL modulation, number of subchannels,
number of symbols, offset in subchannels,
offset in symbols, boosting,
burst type:
FCH, DL-MAP, data, restricted HARQ
Burst list
UL modulation, duration in slots, offset in
subchannels, offset in symbols,
burst type:
data, restricted fast feedback
Burst map graphical display of zone/segment content
defined by burst list
20 The application computes the pilot modulation sequence used for tracking in line with the standard.
21 The application detects the pilot modulation sequence used for tracking the signal to be analyzed.