Atec Rohde-Schwarz_FSL Series - Manual (Page 35)

Version 09.00, December 2008 R&S ® FSL Spectrum Analyzer 35
R&S
®
FSL-K93 WiMAX™/WiBro IEEE 802.16 OFDMA SISO
analysis (IEEE 802.16-2004, IEEE 802.16-2004/Cor1-2005,
IEEE 802.16e-2005, P802.16-Rev2/D3 WiMAX™ and WiBro)
The specifications of the R&S ® FSL-K93 option are based on the data sheet of the R&S ® FSL spectrum analyzer.
Specifications apply under the following conditions: 30 minutes warm-up time at ambient temperature, specified environmental
conditions met, calibration cycle adhered to, and all internal automatic adjustments performed. "Typical values" are designated with
the abbreviation "typ." These values are verified during the final test but are not assured by Rohde & Schwarz. "Nominal values" are
design parameters that are not assured by Rohde & Schwarz. These values are verified during product development but are not
specifically tested during production.
Frequency
RF input
R&S ® FSL3 50 MHz 17 to 3 GHz
R&S ® FSL6 50 MHz 17 to 6 GHz
Frequency range
R&S ® FSL18 50 MHz 17 to 18 GHz
model serial number or lower
R&S ® FSL3 18 100703
R&S ® FSL6 18 100604
R&S ® FSL3 100945
R&S ® FSL6 100759
1.44 MHz to 20 MHz
model serial number or higher
R&S ® FSL3 18 100704
R&S ® FSL6 18 100605
R&S ® FSL3 100946
R&S ® FSL6 100760
1.44 MHz to 32 MHz
Sampling rate F
s
R&S ® FSL18 1.44 MHz to 32 MHz
Level
Level range RF input 60 dBm to +30 dBm
auto
Level setting
manual
Signal acquisition
IEEE 802.16-2004 OFDMA SISO
IEEE 802.16-2004/Cor1-2005 OFDMA
SISO
IEEE 802.16e-2005 OFDMA SISO
P802.16-Rev2/D3 OFDMA SISO Supported standards
IEEE 802.16e-2005 based WiBro
Capture length 24 µs to 15.6 ms
Gate length 24 µs to capture length
Number of analyzed subframes 1 to 10922 subframes
EVM versus symbol, burst summary list,
constellation versus symbol, bit stream capture length 19
FFT spectrum, CCDF capture length or gate length
Result length
result summary, power versus time, EVM
versus carrier, spectrum flatness,
spectrum flatness difference, group delay,
frequency error versus sample, phase
error versus sample capture length 19 or
1 to 10922 subframes
Frame length 2 ms to 15 ms
spectrum mask 2.5 ms to 16000 s, auto Sweep time
adjacent channel power ratio (ACPR) 10 ms to 16000 s
Sweep count 1 to 32767
Trigger modes RF input free run, external, power
17 5 MHz to 50 MHz with restricted functionality depending on bandwidth (power trigger, auto level, IF overload).
18 With tracking generator.
19 Max. 100 zones/subframes per capture buffer, max. 1000 bursts per capture buffer.