Atec Rohde-Schwarz_FSL Series - Manual (Page 23)

Version 09.00, December 2008 R&S ® FSL Spectrum Analyzer 23
R&S
®
FSL-K82 application firmware for CDMA2000
®
base
station measurements
Frequency
RF input
R&S ® FSL3 3 MHz to 3 GHz
R&S ® FSL6 3 MHz to 6 GHz 2
Frequency range
R&S ® FSL18 3 MHz to 18 GHz 2
Level
Level range RF input
60 dBm to +30 dBm
Level setting auto, manual
Signal acquisition
Supported standards CDMA2000 ® BTS
IS-95 BTS
Capture length 2 to 12 power control groups
spectrum mask max. 16000 s, auto Sweep time
ACPR (adjacent channel power ratio) max. 16000 s
Sweep count 1 to 32767
Trigger modes RF input free run, external
Measurement parameters
predefined bands band classes 0 to 17 Frequency band
unspecified limits can be user-specified
Link mode downlink (DL)
Modulation detection BPSK, QPSK, 8PSK, 16QAM
Predefined channel table code domain analyzer The predefined channel table allows the
complete channel setup of the user signal
for the code domain analyzer.
standard in line with band classes 0 to 17 Spectrum emission mask
user The spectrum emission mask
measurement is performed based on
either a manual user setting or a user-
specified XML file.
Result display
global results:
carrier frequency error (reading in Hz and
ppm), chip rate error, trigger to frame,
number of active channels
results for selected power control group:
total power, pilot power, rho, composite
EVM, I/Q imbalance, I/Q offset Result summary min./mean/current/max. values
results for selected power control group:
absolute power, relative power, symbol
EVM, modulation type, timing offset,
phase offset
Code domain power clear write, max. hold, min. hold, average,
view code domain power versus channel
code domain error power versus channel
Peak code domain error clear write, max. hold, min. hold, average,
view peak code domain error power versus
power control group
Power versus power control group clear write, max. hold, min. hold, average,
view power versus power control group for
selected channel
2 All the values specified for R&S ® FSL-K82 in this data sheet are valid up to 3 GHz.