Atec Agilent-E8364A - Manual (Page 23)

Measurement throughput summary
Cycle time vs. IF bandwidth 1 Cycle time vs. number of points 1
Instrument state: preset condition, 201 points, Instrument state: preset condition, 35 kHz IF
CF = 1 GHz, Span = 100 MHz, correction off. Add bandwidth, CF = 1 GHz, Span = 100 MHz, correction
21 ms for display on. Cycle time includes sweep and off. Add 21 ms for display on. Cycle time includes
re-trace time.
sweep and re-trace time.
Cycle time 1 , 2 (ms)
Number of points
51 201 401 1601
Start (fundamental band), IFBW = 35 kHz
Uncorrected and one-port cal 21 23 28 65
Two-port cal 52 57 70 152
Start 45 MHz kHz, stop 10 GHz, IFBW = 35 kHz
Uncorrected and one-port cal 71 79 84 110
Two-port cal 153 171 182 243
Start 45 MHz, stop 20 GHz, IFBW = 35 kHz
Uncorrected and one-port cal 103 116 121 139
Two-port cal 216 245 256 303
Start 45 MHz, stop 40 GHz, IFBW = 35 kHz
Uncorrected and one-port cal 145 181 190 232
Two-port cal 293 367 382 428
Start 45 MHz, stop 50 GHz, IFBW = 35 kHz
Uncorrected and one-port cal 163 210 218 256
Two-port cal 332 425 442 487
Time Domain 3 (increase over uncorrected sweep time)
Conversions <1 <1 4 13
Gating <1 <1 4 17
23
IF bandwidth (Hz) Cycle time (ms)
40,000 8
35,000 9
30,000 11
20,000 13
10,000 28
7,000 36
5,000 48
3,000 72
1,000 196
300 620
100 3853
30 8041
10 19855
Number of points Cycle time (ms)
3 4
11 4
51 5
101 6
201 9
401 16
801 29
1601 55
1. Typical performance.
2. Includes sweep time, retrace time and band-crossing
time. Analyzer display turned off with
DISPLAY:ENABLE OFF. Add 21 ms for display on.
Data for one trace (S11) measurement.
3. Option 010 only. Analyzer display turned off with
DISPLAY:ENABLE OFF. Add 21 ms for display on.