Atec Agilent-E8364A - Manual (Page 21)

General information
Description Supplemental information
System IF bandwidth range 1 Hz to 40 kHz, nominal
RF connectors
E8362A 3.5 mm (male), 50 Ω, (nominal), center pin recession flush to .002 in. (characteristic)
E8363/4A 2.4 mm (male), 50
Ω, (nominal), center pin recession flush to .002 in. (characteristic)
Display 8.4 in diagonal color active matrix LCD; 640 (horizontal) x 480 (vertical) resolution;
59.83 Hz vertical refresh rate; 31.41 Hz horizontal refresh rate
Display range
Magnitude ±200 dB (at 20 dB/div), max
Phase ±180°, max
Polar 10 pico units, min; 1000 units, max
Display resolution
Magnitude 0.001 dB/div, min
Phase 0.01°/div, min
Marker resolution
Magnitude 0.001 dB, min
Phase 0.01°, min
Polar 0.01 mUnit, min; 0.01°, min
CPU Intel ® 500 MHz Pentium ® III
Rear panel
10-MHz reference in
Input frequency 10 MHz ±10 ppm, typ.
Input power –15 dBm to +20 dBm, typ.
Input impedance 200 Ω, nom.
10-MHz reference out
Output frequency 10 MHz ±10 ppm, typ.
Signal type Sine wave, typ.
Output power 10 dB ± 4 dB into 50
Ω, typ.
Output impedance 50
Ω, nom.
Harmonics < -40 dBc, typ.
VGA video output 15-pin mini D-Sub; Drives VGA compatible monitors
GPIB Type D-24, 24-pin; female compatible with IEEE-488
Parallel port (LPT1) 25-pin D-sub miniature connector; provides connection to printers or any other
parallel port peripheral
Serial port (COM1) 9-pin D-Sub; male compatible with RS-232
USB port Type-A configuration (4 contacts inline, contact 1 on left); female
Contact 1 Vcc: 4.75 to 5.25 VDC, 500 mA max
Contact 2 -Data
Contact 3 +Data
Contact 4 Ground
LAN 10/100 BaseT Ethernet; 8-pin configuration
Test set I/O 25-pin D-sub; available for external test set control
Handler I/O 36-pin, parallel I/O port; all input/output signals are default set to negative logic;
can be rest to positive logic via GPIB command
Auxiliary I/O 25-pin connector; analog and digital I/O
21