Pump Solutions Group PZiG Series - Manual (Page 32)

31
Setting
Parameter
s
For defaults, see page 32.
Setting Parameters
Parameter Setup Flow
Manual
STP
P --- 01
P --- 02
P --- 03
P --- **
SET ＋
SET
SET
SET
Hold down the key for at least five
seconds while pressing the SET key in
the stop condition in the manual mode.
*P-01 cannot be set as it is used
for internal processing. FUNC
FUNC
FUNC
FUNC Change
settings.
Change
settings.
Change
settings.
Display Operation Explanation
Make sure that STP, MAN and spm
are displayed.
First, enter the parameter setting
screen by holding down the SET and
UP keys for at least 5 seconds.
This is the parameter number
selection screen.
Change to the desired parameter
number by the UP/DOWN keys. (See
Parameter List on page 32.)
When the desired parameter number
is displayed, press the SET key to
enter the parameter setting change
The current value is displayed.
Set the parameter referring to the
Parameter List on page 32.
The original parameter No. is
displayed.
Press the SET key to apply the
selected value.
SET
RESET
SET
RESET
SET
RESET
FUNC
Setting Parameters
* The parameter setting screen is entered from the
manual mode (pump stopped state).
* Changes made to parameter settings are applied
when the SET key is pressed in the setting change
screen.
Note: You can continue to change other parameter set-
tings until you press the FUNC key.
05-45_PZiG Series(2)English 06.8.4 9:39 AM y [ W 31