Extron Electronics VSC 300_300D User Guide - Manual (Page 42)

Specifications, cont’d
VSC 200/200D/300/300D Specifications A-2
Specifications
VSC 200/200D
Video input
Number/signal type ................... 1 VGA, 1 Mac RGBHV, RGBS, and RGsB
Connectors .................................... VGA ........... 1 15-pin HD female + adapter cables and
Mac ............ 1 15-pin D female
Minimum/maximum levels ...... Analog ....... 0V to 2.0V p-p with no offset at unity gain
Impedance .................................... 75 ohms or High Z (switchable)
Horizontal frequency .................. Autoscan 24 kHz to 81 kHz
Vertical frequency ....................... Autoscan 50 Hz to 120 Hz
Resolution range .......................... Autoscan 560 x 384 to 1280 x 1024
External sync (genlock) ............... 0.3V to 1.0V p-p
The color subcarrier adjustment range is ±180 degrees from 0 for a total adjustment range of 360
degrees.
Video processing
Encoder ......................................... 10 bit digital
Digital sampling .......................... 24 bit, 8 bits per color; 80 MHz
Colors ............................................ 16.8 million
Horizontal filtering ..................... 4 levels
Vertical filtering ........................... 5 levels
Encoder filtering .......................... 3 levels
Video output
Number/signal type ................... 1 RGBHV/RGBS/RGsB or component video, or
1 digital component video (CCIR 601/ITU-R BT.601) (VSC 200D only), or
1 S-video, or
1 NTSC/PAL composite video
Connectors .................................... 5 BNC female .......................... RGBHV/RGBS/RGsB or component video
1 BNC female .......................... digital component video — VSC 200D only
1 4-pin mini-DIN female ....... S-video
1 BNC female .......................... composite video
Minimum/maximum levels ...... 0.0V to 1.0V p-p
Impedance .................................... 75 ohms
Sync
Input type ..................................... Autodetect RGBHV, RGBS and RGsB
Output type .................................. RGBHV, RGBS, RGsB (All RGB formats are switch-selectable.)
Genlock connectors ..................... 1 BNC female ........... genlock input
1 BNC female ........... genlock output (terminate w/75 ohms if unused)
Standards ...................................... NTSC 3.58 and PAL
Input level ..................................... 1.5V to 5.0V p-p
Output level .................................. 5V p-p
Input impedance .......................... 75 ohms
Output impedance ...................... 75 ohms
Polarity .......................................... Negative
Control/remote — scan converter
Serial control port ........................ RS-232, 9-pin female D connector
Baud rate and protocol ............... 9600, 8-bit, 1 stop bit, no parity