Extron Electronics VSC 300_300D User Guide - Manual (Page 15)

2-5 VSC 200/200D/300/300D Installation
Mounting the scan converter
The scan converter ships with four uninstalled rubber feet. If you are going to rack
mount the unit, do so before cabling the unit, and do not install the rubber feet. If
you are not rack mounting the scan converter, skip to “Tabletop/desktop
placement” on page 2-6.
Rack mounting
To rack mount the scan converter, do the following:
1. Attach the mounting brackets (supplied with the scan converter) on either
side of the scan converter, as shown in figure 5. Use four screws per
mounting bracket.
Figure 5 — Installing mounting brackets
Figure 6 — Mounting the scan converter
2. Using two screws per mounting bracket, attach the scan converter to the rack
as shown in figure 6.
OUT
OUTPUTS
VG A
MA C
INPUT/LOOP OUT
VG A OUT
50 /60 H z 0.5 A
10 0-2 40
#8 Screw (4 Plcs) Each Side
MENU
FREEZE/ RESET
GENLOCK NEXT
VSC 200 COMPUTER TO V IDEO SCAN CON VERTER
CENTERING/PAN