Extron Electronics VSC 300_300D User Guide - Manual (Page 3)

Quick Start — VSC 200/200D/300/300D
Installation
Step 1
Install feet on the bottom of the scan
converter (1A), or mount the scan
converter in a rack (1B).
Step 2
Turn off power to the input and output
devices, and remove their power cords.
Step 3
Attach the input and output devices to
the scan converter:
Input cabling (3A):
1. Connect the local monitor to its corre-
sponding (Mac or VGA) 15-pin input/
loop-out (loop-through) connector.
(For 13W3, use the VGA/13W3 cable
provided with the VSC 300/300D.)
2. Connect the computer to the scan con-
verter’s other input connector. (For
13W3, use the Mac/13W3 cable that is
provided with the VSC 300/300D.)
If no local monitor is installed, set the 75
ohm/Hi Z switch to 75W (3C).
Output options (3B) are:
Composite video (connected to VIDEO)
and only any one of the following:
S-video (connected to S-VIDEO)
Digital (connected to D1; VSC
200D/300D)
Component (connected to R/R-Y,
G/Y, and B/B-Y)
RGsB (connected to R/R-Y, G/Y,
and B/B-Y)
RGBS (connected to R/R-Y, G/Y, B/
B-Y, and H/HV)
RGBHV (connected to R/R-Y, G/Y,
B/B-Y, H/HV, and V)
Scaled VGA (connected to VGA
OUT; VSC 300/300D)
Step 4
For RGsB, RGBS, or RGBHV output, set
the sync selection switch (4). (H =
RGBHV, HV = RGSB, SOG = RGsB.)
Step 5
Plug all of the devices into a grounded
AC source, and turn on the input and
output devices.
Step 6
Use the LCD menu screens to configure
the scan converter (see the next page).
PC Input Sun/SGI Input Mac Input
INPUT/LOOP OUT
VGA MAC
INPUT/LOOP OUT
VGA MAC
INPUT/LOOP OUT
VGA MAC
50/60 Hz 0.5A 100-240
INPUT/LOOP OUT G
E
N
L
O
C
K
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
OUT H
HV
SOG
DIGITAL OUT
IN
VGA VGA OUT MAC
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
H
HV
SOG
DIGITAL OUT
VGA OUT
Composite
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
H
HV
SOG
DIGITAL OUT
VGA OUT
S-video
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
H
HV
SOG
DIGITAL OUT
VGA OUT
Digital
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
H
HV
SOG
DIGITAL OUT
VGA OUT
Component
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
H
HV
SOG
DIGITAL OUT
VGA OUT
RGsB
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
H
HV
SOG
DIGITAL OUT
VGA OUT
RGBS
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
H
HV
SOG
DIGITAL OUT
VGA OUT
RGBHV
MENU
FREEZE/ RESET
GENLOCK NEXT
VSC 200 COMPUTER TO V IDEO SCAN CON VERTER
CENTERING/PA N
Mounting Bracket
Each Side with
# 8 Screw (4 Plcs) 1A
3A
1B
3C 4
3B
RS-232
REMOTE
Rubber Feet
Bottom Side
(4 Plcs)
or
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
H
HV
SOG
DIGITAL OUT
VGA OUT
Scaled VGA
H
HV
SOG
50/60 Hz 0.5A 100-240
INPUT/LOOP OUT G
E
N
L
O
C
K
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
OUT H
HV
SOG
DIGITAL OUT
IN
VGA VGA OUT MAC
RS-232
REMOTE
VSC 300
RS-232
Control
VCR
External
Genlock
Timing
Videoconferencing System Monitor
Betacam
Tape Deck
PC Input
Sun/SGI Input
Mac Input
or