Extron Electronics RGB 203 Rxi User Guide - Manual (Page 21)

LCD Display
h
LCD display — The LCD displays the horizontal and vertical scanning rates of the input
signal, and indicates the horizontal and vertical centering status and limits.
LCD screen backlight
The LCD lights for 15 seconds at power-up and it remains lit as long as an input signal is
present at the selected input. To force the backlight to remain off at all times except at
power-up, set
DIP switch 8 (No Backlight) to On (up) (see Rear Panel DIP Switches on
page 8).
Scan rate indication
When the interface is powered on, the LCD lights for 15 seconds while it determines
whether an input sync signal is present. If
DIP switch 8 is set to On (up), the LCD lights
for three seconds only (see Rear Panel DIP Switches on page 8).
z
If the interface does not detect an input sync signal, the LCD goes dark and displays
No Signal until the interface receives an active sync signal.
z
If the interface detects an input sync signal, the LCD displays the horizontal and
vertical scan rates (sync frequencies) in the following format:
Hxxx.xxk
Vxxx.xHz
The first line shows the horizontal rate in kiloHertz; the second line shows the
vertical rate in Hertz.
Centering indications
While the vertical ( { ) or horizontal ( [ ) centering (shift) controls are being adjusted, the LCD
displays H-Shift or V-Shift . That message remains on the LCD (in place of the scan rates)
until the centering control has been inactive for 3 seconds. When a centering control reaches
its minimum or maximum limit, the LCD displays
Min or Ma x on the line below H-Shift or
V-Shift.
Once the centering controls are no longer active, the centering settings are saved, and the
LCD displays the current scan rates.
If
DIP switch 1 (DDSP) on the rear panel is set to On (up, see Rear Panel DIP Switches on
page 8) and a centering control is rotated, the LCD displays N/A DDSP On , and the image
does not shift on screen.
RGB 203 Rxi • Operation 15