Extron Electronics MLM-WB+ User Guide - Manual (Page 22)

Installation, cont’d
MLM-WB • Installation 2-16
#832, 1/8"
Hex Socket
Screw (top & bottom)
Nylon Shoulder Washer
(between outer enclosure
and door, top & bottom;
small diameter inside door)
Adjust top clamp
bracket then tighten
(3) #440 screws.
Adjust left/tight clamp
bracket then tighten
(3) #440 screws.
Installing the Door
After the MLM-WB’s enclosure is securely mounted onto the wall and the VCR has
been installed inside it, attach the door to the outer enclosure by following these steps:
1. Locate the two nylon shoulder washers, and insert the necks of the washers
into the door hinge holes as shown below. The washers will be sandwiched
between the outer enclosure and the door hinges when the door is attached.
2. Align the door hinges (and washers) with the hinge holes in the MLM-WB
outer enclosure.
To avoid muscle
strains and
damage to the
door hinges, have
two people work
together to align
the door with the
enclosure and to
insert and fasten
the socket screws.
9d. Loosen the screws and use a screwdriver to move the vertical clamp
bracket against the rear panel
of the VCR and to push
the horizontal clamp
bracket down
against the VCR.
Tighten the screws to
fasten the brackets in
place.
The VCR should be
snugly fastened in
and should not move
within the
MLM-WB. If the
VCR wiggles/shifts
when touched, adjust
the brackets and
clamp plates so the
VCR does not move
when touched.