Extron Electronics MLM-WB+ User Guide - Manual (Page 13)

2-7 MLM-WB • Installation
5. For each slotted mounting hole ( ) for which you have drilled a pilot hole:
a. Insert a provided masonry screw through a flat metal washer (1”, 2.5 cm
outer diameter; 0.25”, 0.6 cm inner diameter).
b. Insert the screw into the pilot hole.
c. Securely fasten each screw (or toggle bolt) into the wall until a gap of
1/8” (3 mm) remains between the wall and the metal washer.
6. Align the slotted mounting holes in the back of the MLM-WB’s outer
enclosure with the screws and/or toggle
bolts in the wall. Move the MLM-WB
forward over the washers and down as
shown in the illustration at left.
Hanging the outer enclosure on the screws/bolts
7. For each smaller, round mounting hole (in the middle row of holes) for which
you have drilled a pilot hole:
a. Insert a provided masonry screw through a flat metal washer (1”, 2.5 cm
outer diameter; 0.25”, 0.6 cm inner diameter).
b. Insert each screw into the pilot hole.
8. For all the screws (inserted through slotted holes or round holes), firmly
tighten the screws and/or toggle bolts to secure the MLM-WB to the wall.
Installing the MLM-WB on a non-masonry wall
On non-masonry walls the MLM-WB must be attached to at least one stud.
1. Select a location with adequate clearance for the MLM-WB’s enclosure and for
the open door, the extended shelf, and video tape insertion and removal.
2. Locate the wall studs in the area where you will install the MLM-WB, and use
a pencil to mark the studs’ locations on the wall.
3. Hold the MLM-WB’s outer enclosure against the wall, and use a level tool as a
guide for leveling the enclosure. (Lay the level on the top of or on the floor of
A
B