Using the software, Connections menu – Extron Electronics MPS 601 User Guide User Manual
Page 36
MPS 601 • Software Configuration and Control
30
Using the Software
The main PCS window opens on the Configuration page and the Input/Output Config
panel selected. Under the device tab, PCS has two drop-down menus on the toolbar:
Connections
and
Tools
(see figure 21).
Figure 20.
New Device Page
Connections Menu
The
Connections
menu contains options for connecting, disconnecting, and exiting the
program. In the toolbar, click
Connections
below the device tab.
Figure 21.
Connections Menu (MPS 601)
Connect
If the connection to the MPS 601 has not been made, use the following to connect.
The
Connect
indicator is grayed when the MPS 601 is connected.
NOTE: If a device is already connected, the
Connect
option is disabled until the device is disconnected
or the connection times out.
1.
From the toolbar, select
Connections>Connect
. The
Connect
to
Device
dialog opens (shown at right).
2.
Select the connection method from the options (see
3.
Click
Connect
in the bottom right corner to connect to
the device.