Extron Electronics MPS 601 User Guide - Manual (Page 10)

Installation
This section describes the installation and the operation of the MPS 601, including:
• Mounting the Switcher
• Connections
• Contact Closure and Tally Output Application Diagrams
• Lockit Lacing Brackets
• Cabling the MPS 601 Switcher
Mounting the Switcher
The MPS 601 is housed in a 1U, full rack width rack- or desk-mountable metal enclosure.
The switcher can also be surface-mounted under a table, desk, or podium, or on a wall.
See
Mounting Options on page 43 for additional mounting details.
Connections
0.5 A MAX
POWER
12V
1
2
B
A 3
4
5
6
INPUTS MPS 601
CONTACT IN / TALLY OUT
HDMI
RGBHV
HDMI
HDMI RS-232
G C
1 3 5
2 4 6
T T C G T C G
G C T T C G T +V C G
Tx Rx G
OUTPUT
REMOTE
A A B B C C D D E E F F G G
H H
Figure 2. MPS 601 Rear Panel
Power and Input Connections Output Connection Control Device Connections
A DC power connector . E One female HDMI connector. F Contact In/Tally Out — Six
3.5 mm, 3-pole captive screw
connectors for automatic input
switching and tally indication using
Extron Show Me cables.
B Two configurable analog 15-pin
HD (VGA) connectors
.
C Two female 3.5 mm TRS
connectors
(lettered A and B on
the rear panel) corresponding to the
two RGBHV video inputs.
G +V Port — 3-pole 3.5 mm captive
screw connector for +V output.
D Four female HDMI connectors for HDMI compliant
audio and video input (numbered 3, 4, 5, and 6 on the
rear panel).
H RS-232 — 3-pole, 3.5 mm captive
screw connector.
MPS 601 • Installation 4