Extron Electronics MPS 601 User Guide - Manual (Page 31)

Command ASCII Command
(host to switcher)
Response
(switcher to host)
Description
Video output
Set video color bit depth E
V
X$
BITD
}
BitdV
X$]
View color bit depth E VBITD } X$]
Picture Adjustments (RGB Inputs only)
NOTE: The specific input must be selected on the front panel in order to make picture adjustments.
Set pixel phase EX! * X3)
PHAS
}
Phas
X! * X3)]
Set input
X!
to pixel phase
X3)
.
Increment pixel phase value EX! + PHAS
}
Phas
X! * X3)]
Increment pixel phase of input
X!
.
Decrement pixel phase value EX! - PHAS
}
Phas
X! * X3)]
Decrement pixel phase of input
X!
.
View pixel phase value EX!
PHAS
} X3)]
View pixel phase
X3)
of input
X!
.
Set total pixels value EX! * X3!
TPIX
}
Tpix
X! * X3!]
Set total pixels
X3!
of input
X!
.
Increment total pixels value EX! + TPIX
}
Tpix
X! * X3!]
Increment the total pixels
X3!
for
input X! by one pixel.
Decrement total pixels value EX! - TPIX
}
Tpix
X! * X3!]
Decrement the total pixels
X3!
for
input X! by one pixel.
View total pixels value EX! TPIX } X3!] View total pixels X3! for input X! .
Set horizontal start value EX! * X3@ HSRT } Hsrt X! * X3@] Set the horizontal start value X3@ for
input X! .
Increment horizontal start value EX! + HSRT } Hsrt X! * X3@] Increment the horizontal start value
X3@ for input X! by one pixel.
Decrement horizontal start value EX! - HSRT } Hsrt X! * X3@] Decrement the horizontal start value
X3@ for input X! by one pixel.
View horizontal start value EX! HSRT } X3@] View the horizontal start value X3@ of
input X! .
Set vertical start value EX! * X3# VSRT } Vsrt X! * X3#] Set the vertical start value X3# for
input X! .
Increment vertical start value EX! + VSRT } Vsrt X! * X3#] Increment the vertical start value X3#
for input
X!
by one line.
Decrement vertical start value EX! - VSRT
}
Vsrt
X! * X3#] Decrement the vertical start value
X3# for input X! by one pixel.
View vertical start value EX! VSRT } X3#] View the vertical start value X3# of
input
X!
.
NOTES: X! = Input number 1 or 2 for single input addressing
X3) = Pixel phase 0 to 63 (default=32).
X3!
= Total pixels +255 of default value depending on input rate.
X3@ = Horizontal start 0 to 255 (default=128).
X3# = Vertical start 0 to 255 (default=128).
25 MPS 601 • Remote Communication and Control