Extron Electronics MPS 601 User Guide - Manual (Page 16)

Cabling the MPS 601 Switcher
The switcher can be connected to as many as six input devices (RGBHV and HDMI). It can
output to one HDMI device or display. Follow the steps below and the installation example
(see
figure 1 on page 2).
1. Turn off power to the switcher and all devices that will be connected to it.
2. Mount the switcher (see Mounting Options on page 43).
3. Attach up to two analog RGBHV, and four HDMI (or DVI-D with appropriate adapters)
sources (see
Connections on page 4).
4. Connect the HDMI output to a compatible display device (see Connections on
page 4).
5. For analog audio input, connect audio sources to the corresponding audio inputs of the
RGBHV video inputs (see
Connections on page 4).
6. Connect a control PC or controller to the switcher using:
a. The rear panel RS-232 port and a 3-pole captive screw connector (see Remote
Control Port (RS-232) on page 18).
b. The front panel USB configuration port (see Front Panel Configuration Port on
page 19).
7. Power up the input and output devices, then connect power to the rear AC connector
of the switcher.
MPS 601 • Installation 10