Extron Electronics MGP 462D - Manual (Page 45)

3-23 MGP 462 • Operation
4 . Press the Enter button to recall the preset you selected. The LCD screen
shows a message indicating that the preset was recalled. The following
example shows a message indicating that preset 1 was recalled.
WINDOW PRESET
#01 RECALLED
If you want to exit this menu without recalling a preset, repeatedly press the
Preset Recall/Save button until you see the message Window Preset [Enter] to
Exit. Press the Enter button to exit the Window Presets dialog.
Default presets
The following figure shows the factory default preset window configurations.
These presets can be used for any output rate. If you overwrite them, you can
recover them by selecting Factory Defaults from the Advanced Configuration
menu. (See Advanced Configuration menu, earlier in this chapter.)
Window
1
Window
2
Window
1
Window
2
Window
1 Window
2
Window
1
Window
2
Window
1
Window
1
Window
2
Window
1
Window
2
Background Area (solid color)
Background Area (solid color)
Window
2
Window
1
Window
2
Window
1 Window
2
Window
1 Window
2
Preset #1 Preset #2 Preset #3
Preset #5 Preset #6 Preset #7
Preset #9 Preset #10
Preset #4
Preset #8
Factory default preset configurations
Input presets
The MGP 462 has 128 input preset locations, to which you can save signal type,
input configuration settings, picture control settings, and window text for any of
the inputs. These presets can be saved and recalled using the SIS commands via
the RS-232/422 connection or via Ethernet using the MGP 462 Web pages (see
chapters 4 and 5 for further information).
The following settings are contained in the input presets:
Input Type Horizontal Start Total Pixels
Input Name Vertical Start Active Pixels
Film Mode On/Off Pixel Phase Active Lines
Brightness Contrast Color
Tint Detail (sharpness) Image Size/Position*
* Image size and position are saved as percent of the window, so that the input
preset can be used for any size window.