Extron Electronics MGP 462D - Manual (Page 103)

5-19 MGP 462 • Ethernet Configuration and Control
You can perform the following management activities on a window preset after you
select the preset name from this screen.
Naming a window preset
To change the name of a preset, follow these steps:
1 . Select a preset by clicking its button. The name of your selected preset is
displayed in the Window Preset Name field.
2 . In the Window Preset Name field, enter the name you want to give the
selected preset. The following characters are available:
Symbols : : / – + "
Numerals : 0 through 9
Letters : Lowercase a through z, uppercase A through Z
Spaces
3 . Click the Change Preset Name button. The new name appears on the preset
button you had selected.
Saving (creating) a window preset
To save all the current window settings as a preset, do the following:
1 . Click the button for the preset number to which you want to save the current
settings.
2 . Click Save Preset.
Recalling a window preset
To recall a saved preset and enable all its settings, do the following:
1 . Click the button for the preset number that you want to recall.
2 . Click the Recall Preset with Input button to recall all window settings
contained in the selected preset, including the input displayed when the
preset was saved.
If you do not want to recall the inputs for the selected preset, click the Recall
Preset button.
Input Presets screen
The Input Presets screen lets you save and recall up to 128 input presets that each
contain input configuration settings. To create an input preset, you save that
input’s current settings for the following:
Input signal type Tint Vertical start
Input name Color Pixel phase
Film mode Off/On Detail (sharpness) Active pixels
Brightness Horizontal start Active lines
Contrast Image size (as a
percent of the window)