Extron Electronics MGP 462D - Manual (Page 116)

Installing the SDI Card
MGP 462 • Installing the SDI card B-2
Installing a Serial Digital Interface (SDI) Card
The optional SDI input card may be installed in the MGP 462 if the unit does not
already have an input for a serial digital interface signal. The following picture
shows the MGP 462 with the SDI card installed.
MGP main board with SDI input card installed
CAUTION Changes to electronic components must be performed by authorized
service personnel only.
Follow these steps to install an SDI input card in the MGP 462:
1 . Disconnect the AC power cord from the MGP 462 to remove power.
To prevent electric shock, always unplug the MGP from the AC power
source before opening the enclosure.
2 . If the MGP is rack mounted, remove it from the rack, and remove the
mounting brackets, if they are attached.
3 . Remove the cover of the MGP 462 (the top half of the enclosure) by removing
the 14 screws on the top and sides, then lifting the cover straight up.
50 /60 H z
10 0-2 40 V 0. 3A
RG B/ R- Y, B- Y, Y
LA N RE SE T RS -23 2/4 22
2
1
R/
R-Y
R/
R-Y
G/Y
VID
B/C
B-Y
H/
HV
V
G/Y
VID
B/C
B-Y
H/
HV
V
4
3
R/
R-Y
R/
R-Y
R/
R-Y
G/Y
VID
G/
Y
B/
B-Y
B/C
B-Y
H/
HV
VID
/Y
V
VID
SDI
5
6
G/Y
VID
B/C
B-Y
H/
HV
R-Y
/C
V
B-Y
YC
H
V
S
I N
P
U
T
S
O
U
T
P
U
T
S
Lift cover
straight up.
Remove (14)
screws from
top and sides.
Removing the MGP 462 cover
MGP 462 Rear Panel
SDI Connector
SDI Card