Extron Electronics FOX 3G DVC User Guide - Manual (Page 17)

FOX 3G DVC • Operation 11
Powering On
Apply power by connecting the provided IEC power cord to the rear panel power connector
on the DVC. Connect the DVC to an AC power source.
NOTE: Audio and video mute settings are not retained when power is cycled to the
DVC.
Default Cycle
When power is applied, the LCD screen displays the Extron S 3 logo. After approximately 10
seconds, the screen displays EXTRON FOX3G DVC MM or SM. The unit part number and current
firmware version are displayed after approximately another 5 seconds. After those screens,
the default cycle begins, in which the LCD screen alternates every 5 seconds between the
input signal type and data rate, and the input resolution and refresh rate. The default cycle
continues while the menu system is not in use.
The flow diagram below shows the order in which the screens appear at power-up and
during the default cycle.
60-1034-01
F/W V1.00
5 sec.
5 sec.
EXTRON
FOX3G DVC MM
5 sec.
5 sec.
Power
On
10 sec.
INPUT
HDSDI 1.485G
INPUT
720p @59.94Hz
Default Cycle
Figure 10. Power-up and Normal Default Cycle Example
Default Cycle — Special Conditions
The default cycle changes when the following conditions exist:
• No input connected — A single screen is displayed, indicating that there is no input
signal.
INPUT
NO SIGNAL!
Figure 11. Default Screen When No Input Is Connected