Rear panel – Extron Electronics FOX 3G DVC User Guide User Manual
Page 11
FOX 3G DVC • Installation
5
Rear Panel
The illustration below shows the connectors and indicator on the FOX 3G DVC rear panel.
WARNING: Remove power from the system before making any connections.
CAUTION: Use electrostatic discharge precautions (be electrically grounded) when
making connections. Electrostatic discharge (ESD) can damage equipment,
although you may not feel, see, or hear it.
100-240V ~ 0.3A MAX
50/60 Hz
3G/HD/SD-SDI
INPUT
BUFFERED LOOP-THROUGH
OUTPUT
DVI-D
L
R
RS-232
N/A
Tx Rx
AUDIO
LINK
RX
TX
RGB / R-Y, Y, B-Y
1
2
4
5
6
7
3
8
Figure 2.
FOX 3G DVC Rear Panel
a
AC power connector — Plug a standard IEC power cord into this male IEC connector
to connect the DVC to a 100 to 240 VAC, 50 Hz or 60 Hz power source.
b
Tx port (buffered loop-through) — This port of the LC duplex fiber optic input
connector passes a buffered 3G, HD-SDI, or SD-SDI signal through to another
FOX 3G DVC converter or a FOX 3G HD-SDI extender for daisy-chaining (see “
,” later in this section).
c
Rx port (SDI input) — Connect a 3G-SDI, HD-SDI, or SD-SDI source to this port of the
LC duplex fiber optic input connector.
d
Link LED — Lights when a signal is detected on the Rx fiber input.
e
DVI-D output connector — Connect a DVI output device to this female single-link
DVI-I connector (only the digital pins are enabled). RGB or YUV color space is available
on this buffered output. The table below shows the pin assignments for this connector.
8 Not used
16 Hot plug detect 24 TMDS clock–
Pin
Signal
Pin
Signal
Pin
Signal
1 TMDS data 2– 9 TMDS data 1– 17 TMDS data 0–
2 TMDS data 2+ 10 TMDS data 1+ 18 TMDS data 0+
3 Ground (2/4 ) 11 Ground (1/3)
19 Ground (0/5)
4 Not used
12 Not used
20 Not used
5 Not used
13 Not used
21 Not used
6 DDC clock
14 +5 V power
22 Ground (clock)
7 DDC data
15 Ground (for 5 V) 23 TMDS clock+
1
8
17
24
9
Figure 3.
DVI-D Connector Pin Assignments